Hollow Form Printing Concepts

Concept Generation

Each of these objects is designed specifically to be printable as a shell. When creating these concepts I made a scale from fairly safe designs that should easily print, to incredibly risky objects that have a way higher chance of failing. In order to be a printable hollow form object, the design has to be able to support itself and at the same time fall within the parameters set by the printer itself.

For a lot of these objects I designed I used the twist command because not only did it look great but it could support sharper angles without caving in, making a stronger hollow form object.












Although the second design is my personal favourite, I think that designs one, four, and five are pushing the printer to further limits and my be a better choice to pursue. It will be interesting to see how well these objects print.

Comments

Post a Comment

Popular posts from this blog

Papercraft Digital Samples

Image
The point of this project was to design objects in Rhinoceros 3D for papercraft. I did this by initially creating a geometrical 3D object, breaking it apart, and then unfolding just like actual paper. The papercraft objects I chose to design were mostly either inspired by my previous post about paper and light artwork created by Deepti Nair and Harikrishnan Panicker, or were parodies of the object it was based off of.  (Fig. 1) A sword, normally a heavy strong weapon used in combat, now reduced to a light harmless toy.  (Fig. 2) A tank, again a very heavy and powerful war machine, turned into something that can be destroyed with a handheld lighter  (Fig. 3) A small house, with some holes cut out and some drawing on the outside this would look very cool with a light inside, almost like a decorative Christmas village house.  (Fig. 4) A pencil is normally used to write on paper, something that I have done way too much. Now it is turned into paper,...
Read more

Papercraft Prototype

Image
Snowmobile Prototype The reason I chose the snowmobile is because it's a sport that I've been doing since I was very young and it's something I enjoy doing. Additionally the snowmobile is a very challenging concept to try and unfold into a paper craft object. It allows for quite a bit of detail if I feel up to the task. From bumpers and handlebars to headlights and skis. The concept can be simplified fairly easily like what I did for the prototype, but some of the newer snowmobile models are quite complex and leaves room for improvement, which I plan on doing. I based this first design on an old Yamaha that my dad owned, a fairly simple design with nothing that difficult to design and fold. I designed the snowmobile in Rhino and got the initial concept set. I then unfolded it the best I could into a flat template. Once I got the design down and the tabs attached, I realized the design was too long to fit onto the page and still be to scale. So I actually ha...
Read more

Hollow Form Object Collaboration Progress

Image
The Chalice Harrison and I originally chose 3 of each of our concepts to collaborate on. These objects had shown potential not only to look and function great but also to push the boundaries of what the 3D printer Fig. 1 Fig. 2 Fig. 4 Fig. 3 Fig. 5 Fig. 6 These objects included my spiraling water tower-like object (fig.1), Harrison's angular, scaffold like low poly web (fig.2), my faceted seashell spiral (fig.3), his hole filled cube (fig.4), my teardrop arch (fig.5), and Harrison's incredibly detailed almost Roman arch (fig.6). Fig. 7 After some debate we settled on the first two objects, as they seemed the most visually pleasing and most malleable to combine. We started sketching out ideas and toying with concepts in Rhino to try and figure out how we were going to integrate these two objects into each other (fig.7). We both agreed on the idea of creating an object that wasn't just one solid piece, but instead fanned out to c...
Read more